Hard cast bullets don’t lead at 130 PF, but the waxy lubricant will create smoke. Their drawback is that swaged bullets are soft lead and should not be driven over 1,000 fps or leading can occur. Lead bullets have an advantage in that they are often less expensive, and produce lower bore resistance which requires smaller powder charges (and thus less recoil) to achieve the same velocity as plated or jacketed. These bullets are available (in some weights) in lead, plated or jacketed versions. Reloading component bullets are commonly available in weights of 90, 100, 115, 120, 124, 125, 135, 147 and 160 grains. Selecting the bullet weight and load is next. loads, by using the most sensitive primers (Federal) and “crush fit” seat them to 0.006-0.008 below flush with the cartridge base. Those shooting 9mm from a DA revolver with a match trigger in the seven to eight-pound DA pull range will need to emulate. Whether striker-fired or hammer-fired there is enough force to light off virtually any primer. 38 Spl., there are no issues with semi-automatic handguns. With the cases properly prepped, priming is the next step. If not, chambering or barrel leading issues can arise. Regardless of the type of lead or thin-plated bullet used, the case mouth bell must be big enough to prevent shaving lead or plating. That can save a lot of annoyance and wasted reloading time later. It pays to check headstamps on range brass, and if it looks odd, check the primer pocket. These cases will reload normally once the crimp is removed. These headstamps may have a two- or three-letter symbol, or number, a couple of digits indicating the year of manufacture and some bars or other odd symbols. Nor will they have the usual manufacturer’s ID. Military cases do not normally have the caliber noted. And the headstamp is the identifier.Ĭommercial cases always have the caliber “9mm Luger,” along with the manufacturer’s identifier ( FC for Federal, Win for Winchester, RP for Remington, etc.) on the headstamp. Once that is done the case is ready for continuous use. I use a RCBS Trim Mate crimp remover that inserts on a hand tool and reams the primer pocket. Removing the crimp is a simple one-time process. The author’s RCBS tool removes it quickly, in a one-time operation¬-and allows the case to then be continuously reloaded. The case headstamp indicates a crimped-in military primer. That brings the reloading process to a screeching halt while the shell holder is removed and the crushed primer knocked out. They will de-prime and re-size normally, but if the primer pocket crimp is not removed the new primer will not properly seat. It uses a crimped-in primer, and there are a lot of surplus military loads on the market. Those pressure levels give the case a short lifespan, and it’s not worth the bother. I won’t pick up brass on any range where I know 9mm Major is commonly fired. Another option is picking up range brass, and given the popularity of the 9mm there is normally a fair amount laying around at many clubs. law enforcement agencies also sees a large supply of once-fired brass from a number of vendors. New brass is available from companies like Starline. Some maker’s dies require a separate taper crimp die.īrass is easy to come by. A three-die set (like the RCBS) will re-size and de-prime with one die, bell with the next, and seat the bullet and taper crimp it with the third. The reloading process is straightforward. Taper crimping, instead of roll crimping, should always be done with the 9mm. Others may require a fourth die for the taper crimp. Some dies sets allow full reloading with three dies.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |